2012 KTM 150XC Spooge Problem

Question

My 2012 150XC has always had a spooge problem. Bike runs great but the issue is starting to get on my nerves. I use Motorex 50:1 with standard JD Jetting kit. I put the needle clip on 2nd from top. Any suggestions? Thanks,

in progress 0
joe 3 years 5 Answers 516 views 0

Answers ( 5 )

  1. What type of riding (woods, open trails, moto)?How does the plug look? Don’t adjust jetting to spooge, adjust to temp, elevation and humidity. I don’t know your riding, but I think most people run too fat of a pilot jet as they don’t realize how much time they spend in that 1/8 to 1/4 throttle position.

  2. Re pack the muff

  3. My wif’s newly acquired 200 does it also. I’ve went over the jetting and even dropped the needle to lean it out a bit but it still drools. Runs really crisp so I’m not real worried about it.

  4. Jet it so it runs properly and don’t worry about spooge from the muffler. Better to have too much than too little. That said, you could go up to 60:1 with motorex if it bothers you.

Leave an answer

Browse
Browse

Where are Honda motorcycles produced? ( Japan )