2012 KTM 150XC Spooge Problem

Question

My 2012 150XC has always had a spooge problem. Bike runs great but the issue is starting to get on my nerves. I use Motorex 50:1 with standard JD Jetting kit. I put the needle clip on 2nd from top. Any suggestions? Thanks,

joe 6 years 5 Answers 906 views 0

Answers ( 5 )

    0

    What type of riding (woods, open trails, moto)?How does the plug look? Don’t adjust jetting to spooge, adjust to temp, elevation and humidity. I don’t know your riding, but I think most people run too fat of a pilot jet as they don’t realize how much time they spend in that 1/8 to 1/4 throttle position.

    0

    Re pack the muff

    0

    My wif’s newly acquired 200 does it also. I’ve went over the jetting and even dropped the needle to lean it out a bit but it still drools. Runs really crisp so I’m not real worried about it.

    0

    Jet it so it runs properly and don’t worry about spooge from the muffler. Better to have too much than too little. That said, you could go up to 60:1 with motorex if it bothers you.

    0

    Rev it more

Leave an answer to Tommy

Browse
Browse

Where are Honda motorcycles produced? ( Japan )