2013 CF Moto Z6 Temp Gauge Problem

Question

Have a 2013 cfmoto z6. Have a question on the temp gauge even after running it for awhile temperature only stays on one bar. The fan will kick on (after I replaced fan relay fuse and radiator temp sensor) when needed but only fluctuates to two bars at the most. Is this normal for the gauge?

3 years 0 Answers 528 views 0

Answers ( No )

    0

    My 1st sensor that came in mine only ran 2 bars , it gave up around 140 miles. New sensor temp gauge always runs 3 bars at normal operating temps. Before it goes to 4 fan kicks on. I was told 3 bars is normal at operating temperature

    0

    1 bar , or 2 at most at operating temp isn’t normal at all.

    0

    Mine is like Bill’s second one. 3 bars normal and fan comes on at 4. I say replace the temp sensor.

    0

    It’s a brand new temp sensor. Had to replace it cause fan wasn’t coming on. Fan turns on at proper temp but temp on cluster doesn’t fluctuate until I turn off for a min then turn back on then it will show two bars until fan cools it to one then fan shuts off

    0

    My z6 goes to 3 bars then the fan kicks on until it’s down to 1 bar and repeat

    0

    Thanks for the help guys got the part ordered and on the way

    0

    Well crap the part came in (water temperature sensor) replaced the sensor, cranked her up and the gauge is still showing one bar. Any more ideas would be helpful. Thanks 🙂

Leave an answer to Jim

Browse
Browse

Where are Honda motorcycles produced? ( Japan )